


Features
• Cleanflight SPRACINGF3 firmware competitable
• ARM-Cortex M4 MCU
• On-board black box flight log recorder
• 16 PWM I/O lines for ESCs, Servos and legacy receivers. 8 available on standard pin headers. 8 via side mounted connectors
• Full support for OneShot ESCs for easy PID tuning and a sharper response
• Supports SBus, SumH, SumD, Spektrum1024/2048, XBus, PPM, PWM receivers. Built-in inverter
• Dedicated output for programmable LEDs
• Dedicated I2C port for connection of OLED display without needing flight battery
• Battery monitoring ports for voltage
• Built in sensors for altitude and direction. Barometer mounted on the bottom of the board for easy wind isolation
• Buzzer port for audible warnings and notifications
• Wire up using pin headers, JST-SH sockets or solder pads. Use either right-angled or straight pin-headers
• Configuration of the flight controller via a cross-platform GUI (Windows/OSX/Linux)
• Supports a variety of aircraft, tricopters, quadcopters, hexacopters, octocopters
Specfitcations
MCU: STM32F303CCT6 MCU with 256kb Flash
Memory: 8MB High-Capacity Flash
Gyro Sensor: MPU6050
Barometer: MS5611
Compass Sensor: HMC5883
Connector: Micro USB
*For user manual, please visit cleanflight website
Includes:
1 x F3 Flight Controller
2 x 8pin cables
2 x 4pin cables
1 x 24pin straight header
1 x 24pin right angle header
1 x 14pin straight header